Duerkopp Adler 743-221 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Duerkopp Adler 743-221에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 743-221 12 페이지.

Duerkopp Adler 743-221 설치 지침 매뉴얼

3.4 Attaching the Yarn Stand

3.5 Checking the V-belt Tension

6
1
2
3
The yarn stand is enclosed loose.
For a mains connection from above, the connection cable can be
drawn through the tube 2 of the yarn stand.
The compressed air feed can be guided up through the 2nd drilled hole
in the table top and attached to the yarn stand with cable clamps.
Insert tube 2 and screw the nut 4 fast under the work plate.
Align the yarn spool holder 1 and take-off arms 3 parallel to the
rear edge of the table. The yarn spool holder 1 and take-off arms 3
must lie above one another.
1
It must be possible to press the V-belt 2 together approx. 10 mm at the
center.
Setting the V-belt tension
Loosen screw 1.
The drive 3 is swung until the desired V-belt tension is achieved.
Tighten screw 1 again.
4
2
3