- ページ 6

ミシン Duerkopp Adler 743-221のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Duerkopp Adler 743-221 12 ページ。

3.4 Attaching the Yarn Stand

The yarn stand is enclosed loose.

For a mains connection from above, the connection cable can be

drawn through the tube 2 of the yarn stand.

The compressed air feed can be guided up through the 2nd drilled hole

in the table top and attached to the yarn stand with cable clamps.

–

Insert tube 2 and screw the nut 4 fast under the work plate.

–

Align the yarn spool holder 1 and take-off arms 3 parallel to the

rear edge of the table. The yarn spool holder 1 and take-off arms 3

must lie above one another.

It must be possible to press the V-belt 2 together approx. 10 mm at the

center.

Setting the V-belt tension

–

Loosen screw 1.

–

The drive 3 is swung until the desired V-belt tension is achieved.

–

Tighten screw 1 again.