Duerkopp Adler 0791 910700 피팅 지침 매뉴얼 - 페이지 7

{카테고리_이름} Duerkopp Adler 0791 910700에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duerkopp Adler 0791 910700 8 페이지. Laser marking

페이지 인쇄

Anbauanleitung für Lasermarkierungsleuchten

Laser marking light activation

5.1 Switching on a laser marking in addition to a specified seam program

Ausgabe/Edition:

Änderungsindex

04.2007

Rev. index: 0.0

Teilesatz 0910 59 001 4

Fitting Instruction for laser marking

Kit 0910 59 001 4

The laser marking lights are optional assemblies.

The laser marking lights can be allocated to the program storage

location 1... 4.

In the above example, the laser should be allocated to the program

"Riegel". It will then be switched on during the sewing process of

the program.

Procedure:

–

Switch on the sewing machine and wait for the reference run.

–

Select the top line [P: Riegel] using the "" key and activate it by

pressing the "OK" key.

Select "Service-Menu" using the " ¯" key and confirm it by

–

pressing the "OK" key.

Select "Corrections" using the " ¯" key and confirm it by pressing

–

the "OK" key.

Select "Laser/Outputs" using the " ¯" key and confirm it by

–

pressing the "OK" key.

Select the Output 1....7 using the " ¯" key and confirm it by

–

pressing the "OK" key (the status displayed switches from 0 to 1)

0=inactive ; 1=active

–

Switch to the main menu by striking the "ESC" key.

It is possible to operate simultaneously all three laser marking

lights.

Attention !

It is possible to connect and link up to 7 laser marking lights,

depending on the optional assemblies that are installed.

Printed in Germany

Teile-Nr./ Part-No.:

0791 910700

Blatt:

von

Sheet: 7

from 8