Duerkopp Adler 0791 910700 Інструкція з монтажу Інструкція з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу Інструкція з монтажу для Аксесуари Duerkopp Adler 0791 910700. Duerkopp Adler 0791 910700 8 сторінок. Laser marking
Друкувати сторінку
Anbauanleitung für Lasermarkierungsleuchten
5.
Laser marking light activation
5.1 Switching on a laser marking in addition to a specified seam program
Ausgabe/Edition:
Änderungsindex
04.2007
Rev. index: 0.0
Teilesatz 0910 59 001 4
Fitting Instruction for laser marking
Kit 0910 59 001 4
The laser marking lights are optional assemblies.
The laser marking lights can be allocated to the program storage
location 1... 4.
In the above example, the laser should be allocated to the program
"Riegel". It will then be switched on during the sewing process of
the program.
Procedure:
–
Switch on the sewing machine and wait for the reference run.
–
Select the top line [P: Riegel] using the "" key and activate it by
pressing the "OK" key.
Select "Service-Menu" using the " ¯" key and confirm it by
–
pressing the "OK" key.
Select "Corrections" using the " ¯" key and confirm it by pressing
–
the "OK" key.
Select "Laser/Outputs" using the " ¯" key and confirm it by
–
pressing the "OK" key.
Select the Output 1....7 using the " ¯" key and confirm it by
–
pressing the "OK" key (the status displayed switches from 0 to 1)
0=inactive ; 1=active
–
Switch to the main menu by striking the "ESC" key.
It is possible to operate simultaneously all three laser marking
lights.
Attention !
It is possible to connect and link up to 7 laser marking lights,
depending on the optional assemblies that are installed.
Printed in Germany
Teile-Nr./ Part-No.:
0791 910700
Blatt:
von
Sheet: 7
from 8