Cascade 100R 사용자 설명서 - 페이지 8
{카테고리_이름} Cascade 100R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cascade 100R 18 페이지. Integral mount sideshifter, sideshifting fork positioner
페이지 인쇄INSTALLATION
Truck Requirements
Truck Relief Setting
152 bar Recommended
241 bar Maximum
Truck Flow Volume
80R/100R-IFS
80R/100R-ISS
➀ Cascade R-Series Integral Attachments are compatible with
SAE 10W petroleum base hydraulic fluid meeting Mil. Spec.
MIL-0-5606 or MIL-0-2104B. Use of synthetic or aqueous base
hydraulic fluid is not recommended. If fire resistant hydraulic
fluid is required, special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in slow fork positioning
and sideshift speed.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
Auxiliary Valve Functions
Check for compliance with ANSI (ISO) standards:
Hydraulic Supply
IN0019.eps
6
➀
Min.
➁
Recommended Max.
4 L/min.
7.5 L/min.
➂
12 L/min.
IN0018.eps
Tilt Forward
Hoist Down
GA0082.eps
Hoist Up
Tilt Back
Fork Positioning and Sideshift function: No. 8 hose/
No. 8 fittings with 10 mm minimum ID.
Refer to Cascade Hose & Cable Reel Selection Guide,
B
Part No. 212199 to select the correct hose reel for the
mast and truck.
C
Sideshifting
A
Mast Single Internal Reeving
OR
A
B
Hose Reel
Fork Positioning & Sideshifting
A
Mast Double Internal Reeving
OR
C
Mast Single Internal Reeving and Hose Reel
Sideshift
Left
Open Forks (if equipped)
Close Forks (if equipped)
Sideshift
Right
6914838 EN