Cascade 120C 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Cascade 120C에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cascade 120C 10 페이지.

페이지 인쇄

RUCK REQUIREMENTS

WARNING: Rated capacity of the truck/

attachment combination is a responsibility of the

original truck manufacturer and may be less

than that shown on the attachment nameplate.

Consult the truck nameplate.

Truck Relief Setting

2000 psi (140 bar) Recommended

2300 psi (160 bar) Maximum

Truck Flow Volume

Min.

55C, 100C,

5 GPM

120C, 150C (19 L/min.)

Cascade C-Series Fork Positioners are compatible with SAE

10W petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-

5606 or MIL-0-2104B. Use of synthetic or aqueous base

hydraulic fluid is not recommended. If fire resistant hydraulic

fluid is required, special seals must be used. Contact Cascade.

Flow less than recommended can result in slow and unequal

fork movement.

Flow greater than maximum can result in excessive heating,

reduced system performance and short hydraulic system life.

Carriage Mount Dimension (A)

Class II

14.94 in. (380.0 mm)

Class III 18.68 in. (474.5 mm)

Class IV 23.44 in. (595.5 mm)

GA0028.ill

Auxiliary Valve Functions

Check for compliance with ITA (ISO) standards:

GA0082.ill

Recommended

Max.

7 GPM

10 GPM

(26 L/min.)

(38 L/min.)

Minimum

Maximum

15.00 in. (381.0 mm)

18.74 in. (476.0 mm)

23.50 in. (597.0 mm)

Tilt

Forward

Spread Forks

Sideshift

Hoist Down

Left

Hoist Up

Sideshift

Right

Tilt

Close Forks

Back

ITA (ISO)

Carriage

Clean carriage bars and inspect for

damaged notches

GA0080.ill