Airvent UV-C FiltAir 45 사용 설명서 - 페이지 9

{카테고리_이름} Airvent UV-C FiltAir 45에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airvent UV-C FiltAir 45 16 페이지.

Marked Through the Unit

Place the unit at its designated place, and press it firmly against

the wall. Either use the optional feet, or leave at least 120 mm free

space below the unit.

Attention!

After mounting the feet, the unit must be raised to a

vertical position by lifting it from two sides. Do not lift by tilting

it on its feet!

Mark the location of the boreholes on the wall through the

holes on the back sheet of the unit (marked in red), and then

put the unit aside for the duration of drilling. The machine must

be secured against tipping over during the drilling.

Size

UV-C FiltAir 15

UV-C FiltAir 30

UV-C FiltAir 45

UV-C FiltAir 75

Mounting the unit to the wall

The unit, standing on its feet, needs to be placed back to its des-

ignated place and then it must be firmly fixed to the wall in four

places with screws.

The fluorescent lamps to be inserted into the socket at the bottom

and top and rotated 90 degrees to the right or left until they click. Pay

attention to holding them at the bottom and top with both hands.

Attention!

It is recommended to use clean gloves or textile to

insert the fluorescent lamps, or to wipe the tubes with a slightly

damp alcohol swab after insertion. It is not permitted for the user

to open the reactor space and insert the UV-C lamps!

Inserting fluorescent lamps

C (mm)

400

600

1050

Mark the location of the boreholes through the holes on the back sheet of the unit

The filter must be gently pressed into the bottom of the filter

housing until it stops and then tilted into its place. Then fix the

filter by turning the clips.

Inserting the air filter

Ø10

110