Addictive Desert Designs ADD-Lander 빠른 시작 매뉴얼
{카테고리_이름} Addictive Desert Designs ADD-Lander에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Addictive Desert Designs ADD-Lander 5 페이지. 2005-current toyota tacoma overland rack
Addictive Desert Designs ADD-Lander에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지)
페이지 인쇄ADDICTIVE DESERT DESIGNS® ®
ADDICTIVE DESERT DESIGNS
Preparation:
• Disconnect the negative battery terminal. Park the vehicle on level ground and set the emergency brake.
• We recommend reading through the installation instructions in whole before performing the work.
• When button head bolts are being used, install the supplied washer on the nut side. Then, hold the bolt station-
ary and only turn the nut to tighten. Do not turn the bolt to tighten hardware assembly, unless otherwise noted.
• Estimated Installation Time: 2 Hours for Assembly/Installation
**This installation requires 2 people for best results**
**Labor Rates are based on a vehicle with no pre-existing damage. Wiring labor is based on a standard wiring procedure
with light switches installed in an easily accessible location. Custom light triggering or switch mounting location will
result in a greater labor charge.**
You will need the following tools:
- Ratchet
- 5/16" Allen Wrench/Socket
Included in Kit:
12
- Button Head Bolts
12
- Square Rack Nuts
48
- Flat Washers
1
- Button Head Bolts
2
- Chase Rack Cross Member
Addictive Desert Designs® | Page 1
- 9/16" Wrench
(1/2"-13 x 1")
(1/2"-13)
(3/8")
(1/2"-13 x 1 1/2")
2020-Current Jeep Gladiator JT ADD-Lander™
Overland Rack Installation Instructions
- 7/32" Allen Wrench/Socket
13
- Flat Washers
(1/2")
48
- Button Head Bolts
48
- Nylon Lock Nuts
2
- Chase Rack Side Piece
1
- Chase Rack Cross Member
(3/8"-16 x 1")
(3/8"-16)
(No Front Lip)