Dulytek DM1000 사용 설명서 - 페이지 9

{카테고리_이름} Dulytek DM1000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dulytek DM1000 10 페이지. Heat press

페이지 인쇄
INSTRUCTION MANUAL: DM1000
OPERATING INSTRUCTIONS
SETTING
TIMER
PRESSING
TURNING OFF
THE PRESS
Dulytek Equipment
www.dulytek.com
Set up the desired press time in seconds using the timer control panel
1. Press SET button on the timer control panel (Figure 5). SET TIME
indicator becomes lit.
2. Press UP and DOWN buttons until the desired time in seconds is shown
on the display (Figure 6).
3. Press SET button again to record the settings (Figure 7). SET TIME indi-
cator turns off. Tip: the countdown starts when the press handle is low-
ered and the press is locked in.
Figure 5
1. Wait until the platens heat up to the desired temperature. Tip: you should
see the set temperature on the display.
2. Place the material you wish to press in the center of the bottom platen
3. Lower the press handle
mediately.
4. Wait until the press starts beeping indicating the pressing time is up. The
display on the timer control panel should also show "0", and ALARM indi-
cator should be lit as well (Figure 8).
5. Lift up the handle
sets to the saved settings, and ALARM indicator turns off.
6. Remove the pressed material using heat resistant gloves or tools and
exercising extreme caution.
1. Turn the machine off by flipping ON / OFF swith when done pressing.
2. Unplug and then disconnect the AC power cord from the press.
3. Wait until the press cools down completely to store it.
(continued)
Figure 6
F
locking in the press. The countdown starts im-
unlocking the press. Beeping stops. The timer re-
F
C
Figure 7
Figure 8
E
© 2018 Dulytek
All rights reserved
PAGE 8
.
C
H
.