Danfoss VLT FC Series 사용 설명서 - 페이지 10

{카테고리_이름} Danfoss VLT FC Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT FC Series 11 페이지. Igbt module replacement for d1h–d8h drives
Danfoss VLT FC Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (6 페이지)

페이지 인쇄
Danfoss VLT FC Series 사용 설명서
 
By Double clicking the field "DriveIn" of the VLT AOI in the PLC's rung, the corresponding input tags (located in the
Controller Scope of the PLC) will appear as shown in figure 10.
From the drop down list select the input tag that corresponds to the actual drive (e.g. FC302:I1.Data).
New tags can be created by right clicking in the desired field and selecting New tag.
The same procedure must be done with the "DriveOut" field in order to control the drive (e.g. FC302:O1.Data).
After assigning tags to "Run" and "MRV" the Drive can now be controlled in a very easy way, by just calling the AOI, and
setting the RUN bit to true and setting the MRV to a value between 0.0 and 100.0%. If MRV is set to a negative value the
motor will run in CCW (If parameter 4-10 is set to "Both directions")
 
10
®
VLT
MCA 121 EtherNet/IP Add On Instruction
Figure 10
®
MIxxxxxx - VLT
is a registered Danfoss trademark