Danfoss VLT FC Series Talimatlar Kılavuzu - Sayfa 10

Kontrolör Danfoss VLT FC Series için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Danfoss VLT FC Series 11 sayfaları. Igbt module replacement for d1h–d8h drives
Ayrıca Danfoss VLT FC Series için: Kurulum Kılavuzu (12 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar), Kurulum Kılavuzu (8 sayfalar), Kurulum Talimatları Kılavuzu (6 sayfalar), Kurulum Kılavuzu (6 sayfalar)

By Double clicking the field "DriveIn" of the VLT AOI in the PLC's rung, the corresponding input tags (located in the

Controller Scope of the PLC) will appear as shown in figure 10.

From the drop down list select the input tag that corresponds to the actual drive (e.g. FC302:I1.Data).

New tags can be created by right clicking in the desired field and selecting New tag.

The same procedure must be done with the "DriveOut" field in order to control the drive (e.g. FC302:O1.Data).

After assigning tags to "Run" and "MRV" the Drive can now be controlled in a very easy way, by just calling the AOI, and

setting the RUN bit to true and setting the MRV to a value between 0.0 and 100.0%. If MRV is set to a negative value the

motor will run in CCW (If parameter 4-10 is set to "Both directions")

VLT

MCA 121 EtherNet/IP Add On Instruction

Figure 10

MIxxxxxx - VLT

is a registered Danfoss trademark