AOK TX2056A 매뉴얼 - 페이지 7

{카테고리_이름} AOK TX2056A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AOK TX2056A 18 페이지. Rc weather station with bbq weather display and outdoor sensor

Information :

The device will lose all information when switching it on again.

Radio frequency connection

After the device turns on, radio frequency symbol

will flash on the display and it will start to receive RF

signal from wireless sensor for 3 minutes, the corresponding outdoor temperature and humidity values will

be displayed.

If NOT received successfully, press and hold the

button to reconnect.

About the time signal

General

The radio clock built into the weather station receives its wireless signals from the WWVB time signal

transmitter.

As soon as the base station has power from the batteries, it begins receiving and searches for the signal

from the WWVB transmitter. If the time signal is been received in sufficient strength, the date and time are

shown on the display. The base station switches on several times a day and synchronises the time with the

wireless signal from the transmitter WWVB. If there is no reception, e.g. in severe thunderstorms, the device

continues to run precisely and then automatically switches to receiving at the next scheduled time again.

Starting radio signal reception

After received RF signal for 3 minutes, the device will switch to RC receiving mode; the receiving symbol

will flash, and the number of radio waves

on display indicates the quality of reception: The more radio

waves on display, the better the reception.

As soon as the signal has been received with sufficient strength, the corresponding information is shown on

the display and the radio tower symbol

is permanently displayed. This process can take 7 minutes.

The weather station will now switch to receive automatically several times a day and compare the time

displayed with the time received from the time signal transmitter.

If the signal strength is not sufficient, the base unit stops the receiving process and the radio tower symbol

is not displayed any more. The receiving process is then carried out again at a later time.

In this case, the time will continue as normal.

• First, check if the base unit is in a suitable location

• You can restart the receiving process manually or

• You can wait for the base unit to automatically switch back to receiving mode at a later time. The reception

is usually better at night.

• If reception is not possible at your location, you can set the date and time manually; see the next chapter.

Information : All buttons will be invalid when the weather station is in receiving mode except: 1)

SNOOZE/LIGHT

button to illuminate backlight 2) press and hold the

and

button together to exit

signal reception manually.