AOK TX2056A 매뉴얼 - 페이지 9

{카테고리_이름} AOK TX2056A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AOK TX2056A 18 페이지. Rc weather station with bbq weather display and outdoor sensor

페이지 인쇄

General

The base unit and wireless sensor exchange information over a radio frequency. For this reason, the

location is important for the range of the wireless connection. Note:

• The maximum distance between the base station and wireless sensor is 328 ft (

this range is only possible

• Shielding building materials such as reinforced concrete reduce or prevent the radio reception between

the base station and wireless sensor.

• Devices such as televisions, cordless phones, computers and fluorescent tubes can also interfere with the

wireless reception.

• Do not place the base unit and wireless sensors directly on the floor. This restricts the range.

• In low temperatures in winter the battery performance of the wireless sensors can be significantly reduced.

This reduces the transmitter range.

Base unit

DANGER

When installing the device on a wall, there must be no electrical cables, gas or water pipes in the wall at the

installation site. Otherwise there is a risk of electric shock!

• You can put the base unit on the desk or hang it up.

Wireless sensor

• Place or hang the wireless sensor in a place where it is protected from direct weather (rain, sun, wind,

etc.). Suitable locations include e.g. under a porch or in a carport.

Alarm function

The base unit allows you to set two different alarm times. For example, you can set an alarm for the

morning and for after an afternoon nap by activating both alarm times.

MODE

1. Use the

button to select the desired alarm time (A1 or A2).

MODE

2. Hold and press the

The hour indicator of the alarm time (A1 or A2) will flash.

3. Set the desired hour for the alarm with the

MODE

4. Press

to store the setting. The minute indicator will flash on the display.

5. Set the desired minute for the alarm with

MODE

6. Press

to store the setting. The alarm time is set.

Switching the alarm on and off

AL1

AL2

Use the

and

button to switch the alarm on and off.

in open area.

button for approx. 3 seconds once you have chosen the desired alarm time.

and

buttons.

100

meters). However,