Aolait AL400RX 사용자 설명서 - 페이지 8

{카테고리_이름} Aolait AL400RX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aolait AL400RX 14 페이지. 380w 3in1 moving head

Set DMX Address

Click and select the "ADDR", can enter the page of DMX address setting, range from 1 to 512, the

address code shouldn't is not greater than (512- channels quantity), otherwise the light will not

been controlled. Following is the operation:

Enter the page of DMX address, click the blank area in right side of display will pop-up diglog as in

Fig. 4, modify value, then click 'ENTER' to confirm and save DMX address code.

6.2 Address Setting

If you use a universal DMX controller to control the units, you have to set DMX address from 1

to 512

so that the units can receive DMX signal.

Press the MENU button to enter menu mode, select DMX Functions, press the ENTER button

to confirm, use the UP/DOWN button to select DMX Address, press the ENTER button to confirm,

the present address will blinking the display, use the UP/DOWN button to adjust the address from

001 to 512, press the ENTER button to store. Press the MENU button back to the last menu or

idling let the unit idle one minute to exit menu mode.

Please refer to the following diagram to address your DMX512 channel for the first 4 units.

Channel mode

Please refer to below configurations to control the fixtures

Attentions:

1. The unit will maintain the last condition until reset if you cut-off the DMX signal.

2. For the channel Function, keep the value for about 5 seconds, then the corresponding function

will take into effect.

26Channels (Mode 1):

CHANNEL1

CH1

CH2

Unit 1

Address

Designation

PAN

PAN FINE

6/12

Unit 2

Address

Value

0-255

Unit 3

Address

FUNCTION

Pan ：

0° - 540°

Pan Fine ：

Fine Pan positioning

Unit 4

Address