Dunavox DX-119.386DB 사용 설명서 - 페이지 9

{카테고리_이름} Dunavox DX-119.386DB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dunavox DX-119.386DB 17 페이지.
Dunavox DX-119.386DB에 대해서도 마찬가지입니다: 사용 설명서 (19 페이지)

5. INSTALLATION INSTRUCTIONS

•

This Wine Cooler is designed to be free standing installation. Can only be built in when there is

enough room for ventilation, ask your local dealer how to do this safely.

• Remove the exterior and interior packing.

• Check to be sure you have all of the following parts:

Sapele shelves (DX-80.188K 3 pcs, DX-114.270K 4 pcs, DX-

200.450K 5 pcs)

Instruction Manual (hard copy or CD)

• Clean the interior surface with lukewarm water using a soft cloth.

• Place your Wine Cooler on a surface that is strong enough to support it

when it is fully loaded.

• Allow minimum 5 cm of space between the sides and the wall, as well as

minimum 8 cm between the back and the, which allows the proper air

circulation to cool the heat sink.

• Locate the Wine Cooler away from direct sunlight and sources of heat

(stove, heater, radiator, etc.). However the unit supplied with winter

protection (in case of low ambient temperature heats up the unit to the

set temperature), extreme cold ambient temperatures may also cause

the unit not to perform properly.

• Avoid locating the unit in moist areas.

• Plug the Wine Cooler into an exclusive, properly installed-grounded wall

outlet. Do not under any circumstances cut or remove the third (ground)

prong from the power cord. Any questions concerning power and/or

grounding should be directed toward a certified electrician or an

authorized service center.

• After plugging the Wine Cooler into a wall outlet, allow the unit to cool

down for 2-3 hours before placing any items in the compartment.

• Rest the wine cooler for 24 hours after transportation.

• Do not tilt more than 45° during transportation.

INSTRUCTION MANUAL