Duncan SH-8n Invader 배선 다이어그램

{카테고리_이름} Duncan SH-8n Invader에 대한 배선 다이어그램을 온라인으로 검색하거나 PDF를 다운로드하세요. Duncan SH-8n Invader 2 페이지. Humbucker pickup

Congratulations on your purchase of a fine, hand-built, Seymour Duncan electric guitar pickup.

Installing this pickup isn't complicated. If you're handy with tools, it will be a simple and fun project. But

if you have no experience handling red-hot soldering irons, we recommend having a qualified guitar

tech install your pickup.

Basic Installation:

1. Remove the strings from your guitar.

2. Remove the back plate and flip it over.

Wiring Diagram for

3. De-solder the original pickup's wires from the controls. Be sure to remember where

All Seymour Duncan

they were connected. A photo or sketch may help.

Humbucker Pickup Models

4. Remove the original pickup from the pickup cavity.

5. Put the Seymour Duncan pickup into the pickup cavity.

6. Tin the wires from the Seymour Duncan pickup, and then solder them into place.

7. Replace the back plate.

5427 hollister avenue, santa barbara, ca 93111

8. Restring your guitar.

Tel. 805.964.9610 Fax. 805.964.9749

www.seymourduncan.com

9. Adjust the pickup height. Your pickup should be between 1/8" and 1/16" from

the strings when the strings are pressed down at the highest fret.

Visit seymourduncan.com for additional wiring diagrams