Duncan SH-8n Invader Schemat połączeń
Przeglądaj online lub pobierz pdf Schemat połączeń dla Akcesoria do instrumentów muzycznych Duncan SH-8n Invader. Duncan SH-8n Invader 2 stron. Humbucker pickup
Drukuj stronęCongratulations on your purchase of a fine, hand-built, Seymour Duncan electric guitar pickup.
Installing this pickup isn't complicated. If you're handy with tools, it will be a simple and fun project. But
if you have no experience handling red-hot soldering irons, we recommend having a qualified guitar
tech install your pickup.
Basic Installation:
1. Remove the strings from your guitar.
2. Remove the back plate and flip it over.
Wiring Diagram for
3. De-solder the original pickup's wires from the controls. Be sure to remember where
All Seymour Duncan
they were connected. A photo or sketch may help.
Humbucker Pickup Models
4. Remove the original pickup from the pickup cavity.
5. Put the Seymour Duncan pickup into the pickup cavity.
6. Tin the wires from the Seymour Duncan pickup, and then solder them into place.
7. Replace the back plate.
5427 hollister avenue, santa barbara, ca 93111
8. Restring your guitar.
Tel. 805.964.9610 Fax. 805.964.9749
www.seymourduncan.com
9. Adjust the pickup height. Your pickup should be between 1/8" and 1/16" from
the strings when the strings are pressed down at the highest fret.
.
Visit seymourduncan.com for additional wiring diagrams