Danfoss FH-CWD 지침 - 페이지 7

{카테고리_이름} Danfoss FH-CWD에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss FH-CWD 16 페이지.

Instruction FH-CWD Thermostat

7. Frost protection

Using the Frost Protection Mode instead of turning

the thermostat OFF completely may protect against

damages due to low temperatures. The room tem-

perature will be maintained around 5 °C.

Fig. 1 .

• Turn OFF the thermostat by pressing

• Press M Fig.1  for 3 seconds and release.

• Select 01 (00= disabled).

If the room temperature is lower than 5 °C the heating

will be turned ON and

will be shown in the display.

If the room temperature is higher than 7 °C the heating

is turned OFF.

Factory setting is 00.

E1 will be displayed when room sensor failure.

E2 will be displayed when floor sensor failure. E2

will be read when pressing M Fig. 1  to check floor

temperature.

Any case, all relay output would be turned off.

Produced by Danfoss Floor Heating Hydronics 05.2011

VI.CU.B2.02