Danfoss TP7001 series 설치 매뉴얼 - 페이지 15

{카테고리_이름} Danfoss TP7001 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss TP7001 series 20 페이지. Electronic 7 day programmable room thermostat
Danfoss TP7001 series에 대해서도 마찬가지입니다: 사용자 지침 (2 페이지), 빠른 매뉴얼 (4 페이지)

페이지 인쇄

Option 92 - Defi ne Remote Sensor Type

(Remote sensor 3 - Backplate connection d)

This allows type of remote sensor input type to be

defi ned. Press + until Option 92 is displayed, use V or

Λ to select required setting.

0 = No Sensor (Factory setting)

1 = Remote room or Duct sensor, internal sensor

disabled

2 = Remote limit (fl oor) sensor, defi ne setpoint in

option 93

3 = Digital input for window, card reader, or teleswitch,

defi ne functionality in option 94

4 = Outdoor temperature sensor (information only -

no control via sensor reading)

Note: Only one of each type of sensor may be fi tted - the choices

within options 90-92 will automatically be limited once remote

sensor types are chosen.

Option 93 - Set Limit Sensor Set-Point

(One of options 90-92 set to 2)

This allows the thermostat limit sensor to be set,

typical application is fl oor heating. Press + until Option

93 is displayed, use V or Λ to select required setting. If

the temperature sensed by the limit sensor exceeds

the limit setting the output will be turned off until the

temperature has dropped by 2°C. "F10" will fl ash in the

display while the output is disabled.

This option is only possible if one remote sensor

option is set to Remote Limit (Floor) Sensor (Setting

Any value between 20.0ºC and 50.0ºC in 0.5.0ºC steps

Factory setting is 27ºC

The temperature set for the limit point sensor will be determined by

the type of fl oor. The recommended limits are:

Tiles on chipboard and wooden fl oors 27°C

Carpet or vinyl on chipboard 35°C

Tiles on concrete fl oor 40°C

Concrete, screed, etc 45°C

Danfoss Heating