Danfoss ECL Comfort 210 운영 매뉴얼 - 페이지 3

{카테고리_이름} Danfoss ECL Comfort 210에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss ECL Comfort 210 16 페이지. Extended heat cut-out
Danfoss ECL Comfort 210에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (12 페이지), 사용자 설명서 (6 페이지), 설치 매뉴얼 (4 페이지), 설치 매뉴얼 (20 페이지), 운영 매뉴얼 (10 페이지), 설치 매뉴얼 (7 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (16 페이지), 마운팅 매뉴얼 (16 페이지)

ECL Comfort 210 / 296 / 310, Floor (Screed) Drying Program

VI.JM.P2.02

Safety Note

To avoid injury of persons and damages to the device, it is absolutely

necessary to read and observe these instructions carefully.

Necessary assembly, start-up, and maintenance work must be

performed by qualified and authorized personnel only.

Local legislations must be respected. This comprises also cable

dimensions and type of isolation (double isolated at 230 V).

A fuse for the ECL Comfort installation is max. 10 A typically.

The ambient temperature ranges for ECL Comfort in operation are:

ECL Comfort 210 / 310: 0 - 55 °C

ECL Comfort 296: 0 - 45 °C.

Exceeding the temperature range can result in malfunctions.

Installation must be avoided if there is a risk for condensation (dew).

The warning sign is used to emphasize special conditions that should

be taken into consideration.

This symbol indicates that this particular piece of information should

be read with special attention.

Automatic update of controller software (firmware):

The software of the controller is updated automatically when the key

is inserted (as of controller version 1.11 (ECL 210 / 310) and version

1.58 (ECL 296)). The following animation will be shown when the

software is being updated:

Progress bar

During update:

•

Do not remove the KEY

If the key is removed before the hour-glass is shown, you have

to start afresh.

•

Do not disconnect the power

If the power is interrupted when the hour-glass is shown, the

controller will not work.

As this Operating Guide covers several system types, special system

settings will be marked with a system type. All system types are shown

in the chapter: 'Identifying your system type' .