Danfoss VLT HVAC Drive FC 102 설치 매뉴얼 - 페이지 2

{카테고리_이름} Danfoss VLT HVAC Drive FC 102에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT HVAC Drive FC 102 8 페이지. Adjustable frequency drive - safe torque off
Danfoss VLT HVAC Drive FC 102에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 설치 매뉴얼 (20 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (12 페이지), 설치 매뉴얼 (18 페이지), 설치 지침 매뉴얼 (11 페이지), 설치 지침 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (10 페이지), 설치 매뉴얼 (6 페이지), 사용 설명서 (16 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (16 페이지), 사용 설명서 (16 페이지), 설치 지침 매뉴얼 (6 페이지), 설치 매뉴얼 (6 페이지)

Danfoss VLT HVAC Drive FC 102 설치 매뉴얼
Installation Guide | VLT® Wireless Communication Panel LCP 103
Compatible software versions:
VLT® HVAC Drive FC 102: 5.10
VLT® Refrigeration Drive FC 103: 2.10
VLT® AQUA Drive FC 202: 3.10
VLT® AutomationDrive FC 301/FC 302 and VLT® Lift Drive LD 302: 8.03

1.3 Approvals and Certifications

FCC COMPLIANCE NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 1 or more
of the following measures:
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and the receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/television technician for help.
-
Modifications: Any modifications made to this device that are not approved by Danfoss may void the authority granted to
-
the user by the FCC to operate this equipment. RF EXPOSURE COMPLIANCE This portable transmitter with its antenna has
shown compliance with FCC's SAR limits for general population/uncontrolled exposure. The maximum listed SAR level is
0.22 W/kg (body). The antenna used for this device must not be co-located or operating along with any other antenna or
transmitter.
2 | Danfoss A/S © 2020.02
FCC ID: 2ANSELCP-103
N O T I C E
Introduction
AN331428064824en-000101 / 130R0814