Danfoss VLT MCD 200 설치 지침 - 페이지 3

{카테고리_이름} Danfoss VLT MCD 200에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT MCD 200 5 페이지. Usb module
Danfoss VLT MCD 200에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (17 페이지), 설치 지침 매뉴얼 (6 페이지)

페이지 인쇄

MCD USB Module Instructions

4. Configuration

To bring the USB Module on-line:

1. Remove control power and mains supply from the soft starter.

2. Attach the module to the soft starter as illustrated.

3. Connect the module to the PC via a USB cable. The PC should detect the module and the

Hardware Update Wizard will open.

4. Install the supplied USB UART driver to operate the module as follows.

The driver can be found in the USB Comms Drivers folder on the supplied CD. Click on the Browse

button then navigate to the drivers folder and select the appropriate folder for your operating

system.

Click on Ok, then Next. The software will install. If you see a prompt, click Continue Anyway. Once

installation is complete, click Finish.

5. The PC will prompt you to install serial port driver software. Repeat the procedure in

Step 4. You may need to restart your PC once the driver software is installed.

MI.17.C1.02 – VLT

is a registered Danfoss trademark

Configuration