Danfoss APP 11-13 분해 및 조립 지침 - 페이지 5

{카테고리_이름} Danfoss APP 11-13에 대한 분해 및 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss APP 11-13 18 페이지. Changing pistons
Danfoss APP 11-13에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)

페이지 인쇄

Instruction

Disassembling and assembling APP 11-13 and APP 16-22

Using the 13 mm combination wrench,

remove all the bolts on the mounting

flange except the three shown in the

picture in item 9.

WARNING: Do not loosen the two screws

keeping the swash plate in place.

10.

Screw the eye bolt in the M8 hole in the

middle of the flange. Pull it straight

upwards.

12.

Remove the pistons one by one. Be careful

not to scratch pistons. Tilt the retainer plate

to horizontal for easy removal of pistons, if

required.

WARNING: DO NOT USE ANY TOOLS.

180R9228 / 521B1181 / DKCFN.PI.013.A2.02 / 10.2013

Unscrew the remaining three bolts. Turn

each bolt one round at the time to make

sure that the flange is removed as straight

upward as possible.

11. Swash plate must be placed so that its

surface is not scratched. For further dis-

assembling of swash plate, see page 12.

13.

Remove the retainer plate.

Note: As the retainer guide is not

attached to the retainer plate, it might fall

out.