Danfoss APPW 5.1 서비스 매뉴얼 - 페이지 9

{카테고리_이름} Danfoss APPW 5.1에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss APPW 5.1 12 페이지. Disassembling and assembling

Service guide | Disassembling and Assembling, APP(W) 5.1-10.2

7. Scrap the old stop bush (if black) and

place the new white stop bush on top of

the retaining guide.

10. Slide the new shaft seal over the torpedo

with the carbon seal face pointing

upwards (see also drawing on last page).

IMPORTANT: Be careful not to damage

the carbon seal face on the shaft seal.

6. Ensure that no dirt has entered into the

pump.

IMPORTANT: If loose particles are

observed, the pump must be

dismantled and thoroughly cleaned

with clean filtered water.

8. Fit the hollow bush (torpedo) onto the

shaft.

9. Thoroughly wet the torpedo, shaft and

replacement shaft seal with plenty of clean

filtered water. Do not use silicone grease.

11. Use the plastic assembly tool provided,

large diameter pointing downwards, to

press the seal home against the shoulder

of the spacer.

180R9238 | DKCFN.PI.078.F3.02 | 521B1196 | 9