Danfoss PAHT G Series 지침 - 페이지 10

{카테고리_이름} Danfoss PAHT G Series에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss PAHT G Series 20 페이지. Paht and paht g 256-308 disassembling and assembling
Danfoss PAHT G Series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (20 페이지), 분해 및 조립 지침 (20 페이지)

페이지 인쇄
Danfoss PAHT G Series 지침
Instruction
4.
Disassembling and
assembling of the
swash plate
10
Disassembling and assembling PAHT and PAHT G 256-308
WARNING:
Make sure that the surface on the swash
plate does not get any marks.
1. Place the swash plate upside down.
Remove the 2 bolts holding the swash
plate. Remove the mounting flange from
the swash plate.
3. Change the O-ring on the mounting
flange.
180R9268 / 521B1236 / DKCFN.PI.011.B3.02 / 01.2015
2. Check that the O-ring and pin are in good
condition (Provided with sealing set).
4. Mount the swash plate on the 2 pins.
Carefully by hand tilt the unit to
horizontal position and mount the 2 bolts
which hold the swash plate. Tighten the
bolts with a torque of 30 Nm +/-2 Nm.
Finally check the surface on the swash
plate for any marks or foreign particles.
Mount the assembled part on the pump.