Danfoss PAHT G Series 지침 - 페이지 7
{카테고리_이름} Danfoss PAHT G Series에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss PAHT G Series 20 페이지. Paht and paht g 256-308 disassembling and assembling
Danfoss PAHT G Series에 대해서도 마찬가지입니다: 서비스 매뉴얼 (20 페이지), 분해 및 조립 지침 (20 페이지)
페이지 인쇄
Instruction
Disassembling and assembling PAHT and PAHT G 256-308
5. Place housing horizontally. Screw in the
rest of the screws on port flange. Tighten
screws to a torque of 30 ± 2 Nm.
7. Ensure port plate is fitted tightly against
the bottom.
IMPORTANT:
Lubricate port plate with clean filtered
fresh water.
If valve plate is disassembled from
cylinder barrel please see page 11
before continuing.
9. Make sure there is enough free space for
the shaft beneath the housing. Gently
lower cylinder barrel into housing.
WARNING!
If cylinder barrel is dropped or lowered
too fast into housing, main bearing and
shaft bearing might be damaged.
Replacement can only be done at
Danfoss, Nordborg.
180R9268 / 521B1236 / DKCFN.PI.011.B3.02 / 01.2015
6. Place pump vertically. Place 10.5 mm pins
in port flange.
Position port plate by using the two pins.
Do not use force for this operation.
8. Screw eye bolt in cylinder barrel.
10. Unscrew M8 eye bolt.
Place the four springs and spring guide in
cylinder barrel. Springs must be
positioned in the holes.
7