Danfoss VLT 5000 Series 사용 설명서

{카테고리_이름} Danfoss VLT 5000 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT 5000 Series 16 페이지. Frequency converter wobble function
Danfoss VLT 5000 Series에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지), 소개 매뉴얼 (9 페이지), 지침 (4 페이지)

페이지 인쇄

INSTALLATION OF BACK-CHANNEL COOLING KIT FOR FRAMES D3, D4 & E2

This instruction sheet is for the installation of back-channel cooling kits available for the VLT

series drives. These kits are designed and tested to be used with Rittal TS8 enclosures

1800, 2000 and 2200 mm in height. Other enclosure heights are not supported. In addition to

the enclosure a 200 mm vented base/plinth is required.

The minimum enclosure depth is 500 mm (600mm for E2 frame) and the minimum enclosure

width is 600 mm (800mm for E2 frame). The maximum depth and width are as required by

the installation. When using multiple drives in one enclosure mount each drive on its own

back panel and support along the mid-section of the panel. The ductwork kits are very similar

in construction for all frames. The D3 and D4 kits do not support "in frame" mounting of the

drives. The E2 kit is mounted "in frame" for additional support of the drive. These kits can be

used with IP00/ Chassis drives as listed in Table 1 and are suitable for use only with Rittal

TS8 IP20 and UL & NEMA 1 and IP54 and UL & NEMA 12 enclosures.

Using these kits as described removes 85% of the losses via the back channel using the

drive's main heat sink fan. The remaining 15% must be removed via the door of the Rittal

enclosure. (Refer to Note 2 on Page 2 for air flow requirements.)

Table 1. Applicable Frames

and Drives

All D3, D4 and E2 Frames

*** IP00 ONLY ***

VLT4000

(North America)

VLT5000

VLT5000FLUX

VLT6000

VLT8000

VLT HVAC

VLT Aqua

VLT Automation

Instruction No: 175R5640 V3

INSTRUCTIONS

Table 2. Kit Part Numbers

Rittal TS8

Frame D3

Enclosure

Kit Part No.

1800 mm

176F1824

2000 mm

176F1826

2200 mm

Aug 13, 2008 Page 1 VLT

Frame D4

Kit Part No.

176F1823

176F1825

is a registered trademark of Danfoss A/S

Frame E2

Kit Part No.

Does not

fit in 1800

176F1850

176F0299