Duobond RL-eez 매뉴얼 - 페이지 6

{카테고리_이름} Duobond RL-eez에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duobond RL-eez 9 페이지. Windshield removal

Now connect the 12V output to a 12V power supply with a minimum of 8A rated power.

By operating the remote control, the wire will now be winched and cut through the polyurethane adhesive.

Always position the nylon cutting wire around the suction cup with pulley at a correct angle relative to the

winch. The cutting angle changes during cutting. If there is no longer any sharp angle,

the suction cup with pulley must be repositioned so that the correct angle is created again.

After use, store the complete RL-eez system clean and dry in the supplied case.

6 of 9