Free The Tone ARC-4 펌웨어 업데이트 절차 - 페이지 16
{카테고리_이름} Free The Tone ARC-4에 대한 펌웨어 업데이트 절차을 온라인으로 검색하거나 PDF를 다운로드하세요. Free The Tone ARC-4 18 페이지. Audio routing controller
Free The Tone ARC-4에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)
페이지 인쇄
3)
Connect the ARC-4's MIDI IN plug to the MIDI interface's MIDI OUT plug.
4)
On the ARC-4 in Edit mode, select "FIRMWARE UPDATE."
For details, please refer to "Updating Firmware via MIDI (FW-UD)" in ARC-4 Owner's Manual (p.24).
5)
Press the "Send(F4)" button in the lower left section of the SendSx's main screen.
CAUTION! During data transmission, never turn off the power to the ARC-4.
6)
The Display-1 on the ARC-4 counts up from "1" to "100," then shows "-WR-" and goes out.
7)
Both the PS and DIR LEDs above the MODE switch illuminate, the L1–L5 switches' LEDs repeat blinking in turns, and the PS1–PS5 LEDs
illuminate sequentially to show the writing process in progress.
8)
When the PS and DIR LEDs above the MODE switch flashes alternately, then the writing is completed. If the unit does not reboot
automatically, disconnect the power once and then reboot it.
9)
After rebooting, the Display-1 shows "PARAM" and "ID ERR" alternately. Press and hold the MODE switch. The Display-1 indicates
"INIT," the data is forcibly initialized and the unit is restarted.
16