Free The Tone ARC-4 Ürün Yazılımı Güncelleme Prosedürleri - Sayfa 16
Kayıt Ekipmanları Free The Tone ARC-4 için çevrimiçi göz atın veya pdf Ürün Yazılımı Güncelleme Prosedürleri indirin. Free The Tone ARC-4 18 sayfaları. Audio routing controller
Ayrıca Free The Tone ARC-4 için: Kullanıcı El Kitabı (16 sayfalar)
Sayfayı Yazdır
3)
Connect the ARC-4's MIDI IN plug to the MIDI interface's MIDI OUT plug.
4)
On the ARC-4 in Edit mode, select "FIRMWARE UPDATE."
For details, please refer to "Updating Firmware via MIDI (FW-UD)" in ARC-4 Owner's Manual (p.24).
5)
Press the "Send(F4)" button in the lower left section of the SendSx's main screen.
CAUTION! During data transmission, never turn off the power to the ARC-4.
6)
The Display-1 on the ARC-4 counts up from "1" to "100," then shows "-WR-" and goes out.
7)
Both the PS and DIR LEDs above the MODE switch illuminate, the L1–L5 switches' LEDs repeat blinking in turns, and the PS1–PS5 LEDs
illuminate sequentially to show the writing process in progress.
8)
When the PS and DIR LEDs above the MODE switch flashes alternately, then the writing is completed. If the unit does not reboot
automatically, disconnect the power once and then reboot it.
9)
After rebooting, the Display-1 shows "PARAM" and "ID ERR" alternately. Press and hold the MODE switch. The Display-1 indicates
"INIT," the data is forcibly initialized and the unit is restarted.
16