AudioCodes Mediant 1000B 구성 참고 사항 - 페이지 10
{카테고리_이름} AudioCodes Mediant 1000B에 대한 구성 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes Mediant 1000B 20 페이지. Gateway & e-sbc
AudioCodes Mediant 1000B에 대해서도 마찬가지입니다: 빠른 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (8 페이지)
페이지 인쇄
2.2
CLI Command Procedure
Once you have established CLI communication, as described in Section 2.1, you need to
run specific CLI commands for restoring defaults. The CLI command procedure depends
on the type of device you are using.
2.2.1
MSBG Series, GW & E-SBC Series, and Mediant 4000
For the MSBG Series, Gateway & E-SBC Series, and Mediant 4000 E-SBC devices, follow
the procedure below.
To restore factory defaults:
1.
At the CLI prompt, type the username (default is "Admin" - case sensitive), and then
press Enter:
# Username: Admin
2.
At the prompt, type the password (default is "Admin" - case sensitive), and then press
Enter:
# Password: Admin
3.
At the prompt, type the following, and then press Enter:
> enable
4.
At the prompt, type the password again, and then press Enter:
# Password: Admin
5.
At the prompt, type the following to reset the device to default settings, and then press
Enter:
# write factory
The CLI commands mentioned in the procedure are shown in the terminal emulation
program (HyperTerminal) below:
Figure 2-1: CLI for Resetting Device to Default (MSBG Devices)
Configuration Note
10
Restoring Factory Defaults
Document #: LTRT-30302