AudioCodes RX-PAD 페어링 매뉴얼 - 페이지 2
{카테고리_이름} AudioCodes RX-PAD에 대한 페어링 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes RX-PAD 10 페이지. Meeting room controller
AudioCodes RX-PAD에 대해서도 마찬가지입니다: 빠른 매뉴얼 (5 페이지)
페이지 인쇄
4. Cabling
The figure below shows the RX-PAD connector ports.
L-R
Description
Power cable
1
Currently inapplicable. USB Type C.
2
Currently inapplicable. USB Type A Super Speed.
3
Currently inapplicable. HDMI for external video ingest.
4
Network port (PoE)
5
Access the connector ports by unscrewing the two screws to remove their cover.
5. Powering up (PoE)
After connecting the Ethernet cable to the network port (ETH) of the device, RX-PAD powers up.
6. General Pairing pre-requisites
Make sure:
1.
No physical blocks exist between RX-PAD and the MTRfA device.
2.
Both are running the latest GA version released by AudioCodes.
3.
Both are connected to the same network (subnet).
4.
In a wireless environment, PS must power the device (it must be ordered separately); the device
cannot operate over Wi-Fi if the device is powered over ethernet.
5.
For the initial pairing of the out-of-the-box set, make sure that the physical distance between them is
less than 50 cm.
1
2
3
4
P a g e
| 2
5