Danfoss 176F4184 설치 매뉴얼 - 페이지 13
{카테고리_이름} Danfoss 176F4184에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss 176F4184 14 페이지. In-back/out-back cooling kit for fk09a/fb09a and fk10a/fb10a
페이지 인쇄In-back/Out-back Cooling Kit for FK09a/FB09a and FK10a/FB10a
Installation Guide
4.
Attach the front duct cover by fastening 8 M5 nuts (8 mm).
Illustration 12: Front Duct Cover Installation
2.8 Installing the Top Cover
To install the top cover of the cooling kit, use the following steps. See
Procedure
1.
Remove the 2 eyebolts from the top of the frequency converter.
Keep the eyebolts for use when lifting the frequency converter.
2.
Remove 8 M5x14 screws (T25) surrounding the sides and back of the vent in the top of the frequency converter.
3.
Remove 3 M5x12 screws (T25) at the front of the vent in the top of the frequency converter.
Retain the screws from steps 2 and 3 for cover installation.
4.
Adhere the top cover gasket to the underside of the top cover.
5.
Position the top cover over the vent opening in the top of the frequency converter.
6.
Secure the top cover to the frequency converter with the screws removed in steps 2 and 3.
Torque to 2.3 Nm (20 in-lb).
Danfoss A/S © 2023.09
Illustration
13.
AN440656954288en-000101 / 136R0326 | 13
Installation