AudioControl ACX-3.2 소유자 매뉴얼 - 페이지 6

{카테고리_이름} AudioControl ACX-3.2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioControl ACX-3.2 20 페이지. All-weather equalizer & crossover with paging mic

Guided Tour of the ACX-3.2 (continued)

13. Balanced Input – (Located under the cover).

These jumpers allow you utilize or bypass the

balanced input circuitry. Although it is shipped

in the balanced mode, which is often best, it may

be necessary to change this depending upon the

confi guration of the components you use.

14. Mic Signal Routing – (Located under the cover).

From the factory, signal from the microphone is

routed to the rear outputs. This jumper allows you

to route microphone signal to both front and rear

outputs if desired. Watch out for feedback!

15. Ground Isolation – (Located under the cover).

This feature allows you to change the power

supply ground for diff erent systems. When the

ACX-3.2 is shipped from the factory, the jumper

is set to the fully isolated position, which is

generally the best. If you have a ground loop noise

(alternator whine) in your system, experiment

with diff erent settings. To change the settings, turn

the system off , carefully move the black jumper

from the center two pins (Isolated), and move it to

either the top two pins (200 Ω), or the bottom two

pins (Ground).

16. Illumination – (Located under the cover). These

jumpers let you change the back-light illumination

to Cool Blue or Hot Red. Given that we are

acclimated to sun-free life in the rainforest, we

have shipped the ACX-3.2 in the Cool Blue mode.

MIC SIGNAL ROUTING

Front/Rear

1

Rear

Ground

1

Isolated

200Ω

GROUND ISOLATION

Red

1

Blue

ILLUMINATION

Unbalanced

Balanced

BALANCED INPUT

Owner's Enjoyment Manual