AudioControl BVR-10 설치 및 운영 매뉴얼 - 페이지 13

{카테고리_이름} AudioControl BVR-10에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioControl BVR-10 20 페이지. Cat-5 balanced video/audio driver cat-5 balanced video/audio receiver active-balanced series

페이지 인쇄

CTIVE

"The picture on my TV is fuzzy."

1.Adjust the Cable Compensation control on the BVD-10.

This compensates for the increased capacitance on

longer Cat-5 cable runs and sharpens the video image.

"There is hum in the audio signal."

1.Verify that the Cat-5 cable is properly terminated on

both end.

2.Make certain that the system is wired with twisted-pair

cabling.

3.Try turning up the output level on the BVD-10 driver.

4.Make certain there is not a cut in the wiring allowing a

conductor to short to ground (i.e. shield, conduit, cold

water pipe, plenum).

"The sound is distorted."

1.The output level on the BVD-10 may be set too high.

2.The signal level feeding into the unbalanced RCA audio

inputs of the BVD-10 is too high (not likely with con-

sumer grade equipment).

-B

ALANCED