Freedom Enterprise PATCHMODULE01 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Freedom Enterprise PATCHMODULE01에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Freedom Enterprise PATCHMODULE01 13 페이지.

FREEDOM ENTERPRISE

Assembly

Start by soldering the red 8-pin female header.

Solder the two 220 F

Solder the remaining components. If you have any trouble fitting the RCA

jacks and potentiometers to the PCB, please use a plier to straighten out the

component's leads. Beware that two of the 3.5 mm jacks have had a specific

pin removed in order to fit in the PCB.

Clean the flux residue left behind. Finish off by soldering the two 12 mm spring

loaded SMD pin on the back. Make sure they are centred on the pad and

that they make contact with the resistor underneath on the MisMatcher01

board when assembled.

1 RCA Connector A

1.1 RCA Access Point A

2 2.1 mm X 5.5 mm DC Jack

3 RCA Connector B

3.1 RCA Access Point B



electrolytic capacitors, the 270  resistor and LED.