Duplo DP-A125 II 설치 매뉴얼 - 페이지 11
{카테고리_이름} Duplo DP-A125 II에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duplo DP-A125 II 12 페이지. Duprinter
페이지 인쇄7. Replenishing Ink
Replenishing Ink
1. Accessing HELP mode:
Turn the power switch on while simultaneously
pressing the PRINT SPEED keys.
2. Accessing H-04:
Use the NUMERIC keys to enter 0 and 4.,
and then press the PRINT key.
The drum will rotate and the ink pump will
run.
When ink replenishment is completed, the
drum will stop with a beep-beep-beep tone.
It takes approximately 30 seconds to
complete ink replenishment.
3. Turn the power off, and then turn it on again.
4. Perform master making and printing.
Refer to the Instruction Manual for more
details.
IMPORTANT
The image will be light until ink is fully spread
over the drum surface. (Continuously print
approx. 20 pages.)
5. Once ink is fully spread, check the printed
image. If the density varies between the
near and far areas of paper, make adjustment
according to Adjusting Ink Amount.
Adjusting Ink Amount
1. How to adjust ink amount of the knob on the
rear side:
1.1 Lift the stopper of the drum and rotate the
drum by hand so that the master clamp
is located at the top.
Stopper
1.2 Loosen one screw to displace the cover.
IMPORTANT
● After the adjustment, move the cover
back to its original position and secure it
with the screw.
Ink adjusting
knob on the rear side
Ink adjusting knob on the operator's side
Master clamp
Cover
Screw
9