Daniamant Dan WR3 설치 및 유지 관리 지침 - 페이지 3
{카테고리_이름} Daniamant Dan WR3에 대한 설치 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Daniamant Dan WR3 4 페이지. Lifejacket light
페이지 인쇄Operation
The DAN WR3 is switched on automatically when the sensor is immersed in
water, and can be switched off by pressing the on/off button *for one second.
The light can also be activated and deactivated manually by pressing the on/off
button*.
Sensor
Switch
Figure depicts the Sensor Switch and the Manual ON/OFF Button
Maintenance
Routine service
Dan WR3 is maintenance free, but the following checks must be made annually:
1. Inspect the light for signs of damage or corrosion.
2. Press the on/off button for one second and the light will commence
flashing then press the button* once more and the light should deactivate.
3. To test the Sensor Switch – a paper clip may be applied to the 2 water
contacts. It is recommended that the light is activated for 1 minute.
Replacement
The Dan WR3 lifejacket lights have a storage life of 5 years and must be replaced
by the date shown on the label.
Health and safety information
Dan WR3 lights contain Lithium cells. These must be handled correctly:
•
Do not dismantle the light assembly
•
Do not make any external electrical connection
•
Do not recharge
•
Do not incinerate
Store between -30°C and +65°C
3
ON/OFF
Button