Daniamant Echopilot FLS 3D 매뉴얼 - 페이지 5

{카테고리_이름} Daniamant Echopilot FLS 3D에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daniamant Echopilot FLS 3D 17 페이지. Forward looking sonar

Industrivej 24C

DK-3550 Slangerup

Denmark

FLS 3D

Tel. +45 4737 3800

Fax: +45 4737 3809

www.daniamant.com

To Switch off:

To switch off the EchoPilot 3D press the power button. The Echopilot logo will appear and a

message saying "shutting down" will appear. The shutdown takes approximately 10 seconds. Once

the system is off the display will become blank and the LED on the keypad will turn off.

It is also possible to execute a forced shut down of the system by pressing and holding the power

button for three seconds. This is bad practice and should only be done in emergency situations

where sonar blackout is required immediately.

To Change Range:

To change range, use the up and down keys on the Keypad. Use the up key to increase the range

and the down key to decrease the range. If you press the up or down key several times it will jump

instantly to the required range. For example, if you are on the 40m range and you press the up key

three times the range will jump instantly to the 100m range.

Range settings:

40m, 60m, 80m, 100m, 150m, 200m

2. Setup Instructions

Settings Menu:

In order to access the settings menu, press the menu button. The left/right keys move between the

settings. The up/down keys change the values of the current setting. The enter key saves the

changes to the settings and closes the settings screen.

Com Port

This value should be set to COM 1.

Units

This value can be set to either metres or feet.

Bow offset

This value should be set to the distance that the transducer is set back from the bow.

Depth Below Waterline

This value should be set to depth that the transducer is below the waterline.

FLS 3D Manual Version 1

Daniamant A/S