AEV ACUO 908 Series 빠른 매뉴얼 - 페이지 15

{카테고리_이름} AEV ACUO 908 Series에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEV ACUO 908 Series 17 페이지. On air broadcast console

Logic GPI/O port

•

GPO 1 Out ( Start / Stop A) through the encoder master to the voice GPIO1 (Start

/ Stop A) select the channel assignment, so when the channel will in Start, the

contact between 1 and 9 will close, with the channel in Stop the contact is open .

•

GPO 2 Out ( Start / Stop B ) through the Master encoder select GPIO2 (Start /

Stop B) and select the channel assignment, so when the channel will put in Start,

the contact between 2 and 10 will close , with the channel put in Stop the contact is

open.

•

GPO Tally : Endcoder in each channel, through the Encoder, to the item TALLY set

ON , so closes the contact between pins 3 and 11 will close when the channel is put

in Start

•

GPO 3 : Endcoder by the Master, under GPO3 select the channel assignment , so,

the contact between pins 4 and 12 will close when the channel will put in Start in,

the contact will open when you put in Stop the channel.

•

GPI 1 ( In Start/Stop A) : through the Master encoder select GPIO1 (Start/Stop

A) and select the channel assignment, in which way , from the outside, through a

circuit to activate the photo - coupler placed between the pins 5 and 13, states Start

and Stop will alternate in the channel , the status of which will be remote using the

control Out Start/Stop A

•

GPI 2 ( In Start/Stop B ) through the Master encoder select GPIO2 (Start/Stop

B) and select the channel assignment, in which way , from the outside, through a

circuit to activate the photo - coupler place between pins 5:13 states will alternate

start and stop of the channel , the status of which will be using the remote control

Out Start/Stop A

AEV Broadcast Srl, via della Tecnica 33 – 40050 Argelato (BO) Italy

ACUO 908 Serie - AEV ON AIR CONSOLE

Web site www.aev.eu