Audiolab 6000CDT 사용자 지침 - 페이지 6

{카테고리_이름} Audiolab 6000CDT에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiolab 6000CDT 13 페이지.
Audiolab 6000CDT에 대해서도 마찬가지입니다: 사용자 지침 (13 페이지)

Important Safety

Controls and Connectors Remote Handset

Introduction

Information

5: Connections

Digital Outputs

Coaxial and Optical output

suitable Digital coaxial (fully screened) interconnect or optical

Audiolab 6000CDT has a pair of trigger connections on the rear panel that can activate 6000A's

or any other source's trigger input. If you have an 6000 system, we advise connecting the

triggers. This will enable all 6000 units to be brought in and out of standby using the trigger

connections. To connect to your control unit, you will need a cable with one end to match the

trigger output of the control unit and other terminating in a 3.5mm jack plug. For Audiolab

6000series, this will be a 3.5mm to 3.5mm interconnect.

OFF

RIGHT

330

OUTPUT

6000A

OPT1

OPT2

LINK

DIG1

DIG2

Connections

Operation Warranty Coverage Speciﬁcations

Mains Input

your system have been properly and securely made. Make sure the ON/OFF switch on the

supplied, connect the socket on the back of your 6000A to an AC supply outlet. The 6000A is

now ready for operation.

OUT

AUX1

AUX2

AUX3

Page 5