Audiolab 6000CDT Інструкція користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція користувача для Конвертер мультимедіа Audiolab 6000CDT. Audiolab 6000CDT 13 сторінок.
Також для Audiolab 6000CDT: Інструкція користувача (13 сторінок)

Друкувати сторінку
Important Safety
Controls and Connectors Remote Handset
Introduction
Information
5: Connections
Digital Outputs
Coaxial and Optical output
suitable Digital coaxial (fully screened) interconnect or optical

Trigger Connections

Audiolab 6000CDT has a pair of trigger connections on the rear panel that can activate 6000A's
or any other source's trigger input. If you have an 6000 system, we advise connecting the
triggers. This will enable all 6000 units to be brought in and out of standby using the trigger
connections. To connect to your control unit, you will need a cable with one end to match the
trigger output of the control unit and other terminating in a 3.5mm jack plug. For Audiolab
6000series, this will be a 3.5mm to 3.5mm interconnect.
ON
OFF
RIGHT
330
-
OUTPUT
6000A
IN
OPT1
OPT2
LINK
DIG1
DIG2
Connections
Operation Warranty Coverage Specifications

Mains Input

your system have been properly and securely made. Make sure the ON/OFF switch on the
supplied, connect the socket on the back of your 6000A to an AC supply outlet. The 6000A is
now ready for operation.
OUT
L
R
P
RE
AUX1
AUX2
AUX3
Page 5