Audionet AMP III 사용자 설명서 - 페이지 11

{카테고리_이름} Audionet AMP III에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audionet AMP III 16 페이지. Three channel power amplifier
Audionet AMP III에 대해서도 마찬가지입니다: 소유자 매뉴얼 (11 페이지)

페이지 인쇄

5.2

Speaker terminals

Now, connect your speakers to the gold plated terminals on the back

panel. The assignment to the respective line input is clearly indicated.

Note

Look out for the correct connection of your speaker cables. Usually,

the terminals of your speakers are marked '+' and '-'. The AMP III

uses the same marks.

Wrong speaker polarization will result in severe loss of sound quality!

Important

Although the AMP III has an effective protection system to pre-

vent damage to the circuits, switch off the unit while working on

the speaker and/or audio cables.

The nominal loudspeaker impedance should be 4 Ohms or higher.

Never use force or tools tightening the terminal screws.

Operating

6.1

Switching on/off

First switch on the AMP III using the mains switch 5 on the back panel.

For about 2 seconds the LED will flash rapidly while the unit is initial-

ized. Afterwards, the AMP III is in stand-by mode; the LED is off.

Press power key on the front panel to switch on the unit. The LED on the

front panel reports the polarization of mains phase for a few seconds (see

sections 'Mains phase detection') until the speaker outputs are enabled.

The AMP III is now ready to playback music.

To switch off the AMP III press power key on the front panel again. The

unit is in stand-by mode; the LED is off.

Note

During shut down procedure the LED will flash 7 times. Before you

can switch on the AMP III again, you have to wait until the shut

down procedure is finished and the LED if off. Do not switch off the

amplifier with the mains switch 5 at the back panel during shut

down procedure.