Audionet AMP III 사용자 설명서 - 페이지 12

{카테고리_이름} Audionet AMP III에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Audionet AMP III 16 페이지. Three channel power amplifier
Audionet AMP III에 대해서도 마찬가지입니다: 소유자 매뉴얼 (11 페이지)

페이지 인쇄

6.2

Mains phase detection

The AMP III is able to detect the correct polarization of the mains plug.

After pressing the power key until the speaker outputs are enabled, the

LED will flash in different rhythms:

If the polarization is correct, the LED flashes slowly: Ä___Ä___Ä...

If you see the LED flashing rapidly: Ä_Ä_Ä_Ä_Ä... please switch

off the unit and flip the mains plug. If you now switch on the

AMP III again, the unit should show the correct mains polarization

by a slowly flashing LED.

6.3

Audionet Link

For your convenience, the AMP III can be controlled remotely by one of

Audionet's multi-channel pre amplifiers MAP or MAP 1, as well as one

of Audionet's stereo pre amplifiers PRE or PRE 1 using the 'Audionet

Link' interface.

You only need a simple optical 'Toslink' cable to connect the 'Audionet

Link' output of your Audionet pre amplifier to the 'Audionet Link' input

10 of your AMP III. Now, the AMP III will be switched on/off auto-

matically, when you switch on/off your pre amplifier at the front panel or

by remote control.

In case you would like to automatically control further Audionet units in

your system with the 'Audionet Link' interface, please connect the

'Audionet Link' output 9 of your AMP III to the 'Audionet Link' input of

the next Audionet unit using a simple optical 'Toslink' cable.

Note

The 'switch on' signal is issued to any further Audionet units daisy

chained to the 'Audionet Link' output of your AMP III with a little

delay to avoid all units switching on at the same moment, which

could cause an overload of your mains fuse.

Independently from the 'Audionet Link' interface, you can switch

on/off your AMP III at any time by using the power key on the front

plate.