Audionet AMP III Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Audionet AMP III. Audionet AMP III 16 pagina's. Three channel power amplifier
Ook voor Audionet AMP III: Gebruikershandleiding (11 pagina's)

Audionet AMP III Gebruikershandleiding
6.2

Mains phase detection

The AMP III is able to detect the correct polarization of the mains plug.
After pressing the power key until the speaker outputs are enabled, the
LED will flash in different rhythms:
·
If the polarization is correct, the LED flashes slowly: Ä___Ä___Ä...
·
If you see the LED flashing rapidly: Ä_Ä_Ä_Ä_Ä... please switch
off the unit and flip the mains plug. If you now switch on the
AMP III again, the unit should show the correct mains polarization
by a slowly flashing LED.
6.3

Audionet Link

For your convenience, the AMP III can be controlled remotely by one of
Audionet's multi-channel pre amplifiers MAP or MAP 1, as well as one
of Audionet's stereo pre amplifiers PRE or PRE 1 using the 'Audionet
Link' interface.
You only need a simple optical 'Toslink' cable to connect the 'Audionet
Link' output of your Audionet pre amplifier to the 'Audionet Link' input
10 of your AMP III. Now, the AMP III will be switched on/off auto-
matically, when you switch on/off your pre amplifier at the front panel or
by remote control.
In case you would like to automatically control further Audionet units in
your system with the 'Audionet Link' interface, please connect the
'Audionet Link' output 9 of your AMP III to the 'Audionet Link' input of
the next Audionet unit using a simple optical 'Toslink' cable.
Note
·
The 'switch on' signal is issued to any further Audionet units daisy
chained to the 'Audionet Link' output of your AMP III with a little
delay to avoid all units switching on at the same moment, which
could cause an overload of your mains fuse.
·
Independently from the 'Audionet Link' interface, you can switch
on/off your AMP III at any time by using the power key on the front
plate.
12