aevit SMART-SHIFT 설치 매뉴얼 - 페이지 6

{카테고리_이름} aevit SMART-SHIFT에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aevit SMART-SHIFT 16 페이지.

TOYOTA SIENNA (2004-2010)

CABLE

BRACKET

Attach the cable bracket (included in KIT-SS-ASSY-

04T) to the end of the Smart Shift bracket in the

location shown in the figures above. The flat side of

the bracket should be facing away from the actuator.

Secure this bracket using the (2) provided #10-32 x

3/8" button head screws and a small amount of Blue

Loctite®.

Secure the shift cable to the Smart Shift by sliding

the end of the OEM cable onto the Cable Bracket.

2004-2010

TOYOTA SIENNA

Attach the Smart-Shift pin (included in KIT-SS-ASSY-

04T) to the Nose Cone using the supplied #6-32 x

3/8" button head screw and Blue Loctite®. Hint: Use

the 3/8" hole directly beneath the nose cone to gain

access to the underside of the nose cone in order to

insert and tighten the screw as shown.

After calibration (see Section 3), verify that the cable

is in Park. Snap the shift cable over the pin on the

Nose Cone.

#6-32 x 3/8" BUTTON

HEAD SCREW

SMART SHIFT

USE THE 3/8" HOLE

IN THE BRACKET TO

GAIN ACCESS TO THE

UNDERSIDE OF THE

NOSE CONE.

SMART-SHIFT INSTALLATION