aevit 2.0 설치 매뉴얼 - 페이지 15

{카테고리_이름} aevit 2.0에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aevit 2.0 17 페이지. Mounting brackets

페이지 인쇄

SECONdArY INpUT

3.3 SECONdArY FUNCTION SwITChES

The most commonly used switch to operate secondary functions

is the 1.5" Push-Button switch (Figure 33). This switch can be used

to operate the 2.0 Digitone, VIC 2.0 and other single secondary

functions. The same bracket system used to mount the AEVIT 2.0

Display can be used to mount this single switch.

sTEP 1

Attach the 1.5" Push-Button switch to a Mounting

Ball using a small piece of double sided tape.

sTEP 2

Attach this assembly and the second mounting

ball to the Vertical Support as shown in Figure 35.

The completed assembly should look like Figure

36.

sTEP 3

Finally, this assembly can be mounted anywhere

convenient for the client to access. A common

place to locate this switch is on the "B" Pillar as

shown in Figure 37. In this position, a client could

easily use their elbow to activate the switch. how-

ever, any place where the Mounting Ball can be

securely attached can be used. EMC recommends

that a bracket be fabricated and mounted to a sup-

port pillar of the vehicle and the Mounting Ball be

attached to it (hardware not included). Figure 38

shows an example of this.

FIGuRE 38

FABRICATED

BRACkET

(ATTACHED

DIRECTLY TO THE

"b" PIllAR)

HARDwARE FOR

INSTALLINg SECOND

MOuNTING bAll, Is

NOT INcluDED.

DOublE

sIDED TAPE

MOuNTING

BALL

FIGuRE 34

vERTICAL

suPPORT

SECOND

MOuNTING

BALL

FIGuRE 35

AEVIT 2.0 MOUNTING BRACKETS INSTALL MANUAL

FIGuRE 33

1.5" Push-buTTON

SwITCH

FIGuRE 36

FIGuRE 37

3-2