3xLogic VX-2A-B-IWD (R) 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} 3xLogic VX-2A-B-IWD (R)에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3xLogic VX-2A-B-IWD (R) 13 페이지.

7 Factory Default

Resetting the device back to the factory default will reinitialize all parameters including the IP address back to

the factory defaults. To reset back to the factory default:

Steps:

1).

Press the reset button and hold it while the device is in use.

2).

Release the button after about 10 seconds.

3).

Wait for the system to reboot.

NOTE:

Factory Default Connection Settings

IP Address

Network Mask

Gateway

User ID

Password

VIGIL Connect allows VIGIL VMS users to remotely connect to a VIGIL Server/V-Series All-in-One camera using

the system serial number or a user defined VIGIL Connect alias, without the need for extensive changes to an

existing network's settings. This allows for the device to be networked with other VIGIL suite utilities with little

effort and minimal knowledge of the device's network connection values.

Steps:

1). To configure a VIGIL Connect alias, navigate to the camera's Basic Tab>Camera Configuration Menu>Site

Information Settings page.

2). Fill in the VIGIL Connect Alias field with an alias of your choosing.

3). Click Apply to save the new alias.

10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC

192.168.XX.YY

255.255.0.0

192.168.0.1

admin

12345

Figure 4-6: Configuring a VIGIL Connect Alias

VISIX Camera Quick Start Guide | VX-2A-B-IWD (R)