Dansons Group 10569 조립 설명서 - 페이지 6

{카테고리_이름} Dansons Group 10569에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dansons Group 10569 20 페이지. Wood pellet vertical smoker

6. ATTACHING THE HEAT SHIELD

Parts Required:

Heat Shield (#21)

#10–24x½" Screw ( #D)

Installation:

•

Position the heat shield between the control board and the grease

exhaust tube. Secure using a screw on each side.

IMPORTANT: If this part is not installed correctly, the heat and/or splatter

from the grease exhaust tube may cause damage to the control board.

Grease damage to the rear of control board is not covered by warranty.

Parts Required:

Power Cord Bracket (#12)

#10–24x½" Screw ( #D)

Installation:

•

Locate the two holes on the bottom of the (left side) support bracket.

Mount the power cord bracket to the support bracket using two

screws as shown in 7A.

•

Next, loosen the nut on the pre-mounted clip bracket and guide the

power cord through the clip bracket. Once through, tighten the nut,

and wrap the power cord on the bracket until unit is in use. Note 7B, 7C.

Parts Required:

Wire Components Housing (#19)

Grease Tray Brackets (#17)

#10–24x½" Screw ( #D)

Installation:

•

First, mount the wire components housing onto the base of the auger

housing using two screws in each bracket. Note 8A.

•

Secure the grease tray brackets onto the base of the auger housing

and the wire components housing using two screws in each bracket.

Note illustration 8B for proper placement.

NOTE: The diveted end of the brackets should face the control board.

•

Fully-tighten all screws on the cart base. Next, carefully turn the unit

into an upright position, with the wheels are on the bottom.

17-1

17-2