Abus Secvest FU8006 빠른 매뉴얼 - 페이지 2

{카테고리_이름} Abus Secvest FU8006에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abus Secvest FU8006 2 페이지.

Abus Secvest FU8006 빠른 매뉴얼
Insert the batteries with the correct polarity.
Close the unused cable inputs using the plugs
provided.
Suspend the centre at the top of the base plate and
reconnect the ribbon cable to the connection in the base plate. Fold
the front housing side downwards and fasten it using the two housing
screws.
Attach the mains power supply to the centre.
IMPORTANT:
When starting the centre for the first time, you will
be prompted to select your language.
Secvest QuickGuide programming
Secvest
Secvest
Secvest
QuickGuide programming
QuickGuide programming
QuickGuide programming
There is a difference between the installer menu and user menu when programming the centre. A user code and an installer code are required. To access the installer menu, press
the key under the "Menu" display. Enter your installer code (7890
information can be found in the installation instructions.
Insert the batteries in the detector, then press the tamper contact on the detector (open). The centre acknowledges reception with a confirmation tone.
If a false alarm is triggered accidentally, then this can be acknowledged by entering the administrator code (1234
menu is accessed. This means that all detectors can be opened without triggering an alarm. Some examples of training detectors are found below. When other detectors are used,
consult the corresponding manuals for further information. Details on programming the zone settings can be found in the installation instructions.
Tamper contact
(wall break contact)
The user menu must be accessed in order to change user codes and train chip keys, wireless cylinders or remote control units. Leave the installer menu and access the user menu by
pressing "Menu", then entering the administrator code (1234
For example, select "Telecommands" in the menu to assign a remote control unit to this user. The SecvestKey wireless cylinder is also trained in this menu.
Press the key for
around 2 seconds
until the red LED
7890) and then the user code (1234
1234). Follow the instructions in the display to train the wireless detector. Detailed
7890
7890
1234
1234
Tamper contact
Front and
rear side
1234).
1234
1234
Press the key for
around 1 second,
then turn the knob
1234). The system does not react to tamper messages when the installer
1234
1234
Press the test
button for about
10 seconds